4D Systems, Australia


GPS-PA6B module assembled DIP version
This product us RoHS compliant This product is PbFree

Datasheet download Datasheets
Download Circuit Diagram
Updated on 09 Aug 2011

Download Application Notes
Updated on 20 Mar 2010

Download GPS-PA6B Data Sheet Rev. A07a
Updated on 20 Jun 2012


This is the GPS-PA6B surface mount GPS module fully assembled on the GPS-PA6B-BREAKOUT board. No soldering or assembly is required as the module is ready to be used. It provides the user a convenient way to directly access all the pins on the GPS-PA6B module via two standard 5 pin headers.


  • Based on MediaTek Single Chip Architecture, MT3329.
  • Module Dimensions : 23.4mm x 20.9mm x 7.6mm.
  • Patch Antenna Dimensions : 15mm x 15mm x 4mm.
  • L1 Frequency, C/A code, 66 channels.
  • High Sensitivity : Up to -165dBm tracking, superior urban performance.
  • Position Accuracy : < 3m CEP (50%) without SA (horizontal).
  • Support up 210 PRN channels.
  • Jammer detection and reduction.
  • Multi-path detection and compensation.
  • Cold Start : under 35 seconds (Typical).
  • Warm Start : under 34 seconds (Typical).
  • Hot Start : under 1 second (Typical).
  • Low Power Consumption : 48mA during acquisition, 37mA during tracking.
  • Low shut-down current consumption : 15uA, typical.
  • Support AGPS function (Offline mode : EPO valid up to 14 days).
  • DGPS(WAAS, EGNOS, MSAS) support (optional by firmware).
  • UART interface, 4800 baud.
  • USB interface.
  • Supports NMEA0183 V3.01 data protocol.
  • FCC E911 compliance.
  • RoHS Compliant.

Copyright © 2012 4D Systems Pty Ltd, Sydney, Australia - All Rights Reserved | Terms and Conditions